Intel Agilex F Series User Manual page 11

Fpga (two f-tiles) development kit

Hide thumbs Also See for Agilex F Series:

Table of Contents

3. Power Up the Development Kit

739942 | 2022.09.21

Note: Use only the supplied power supply. Power regulation circuits on the board

3. Set the power switch (SW5) to the ON position.

When the board powers up, the blue power-on LED (D2) illuminates signaling the

board is ready for use. Since the default configuration mode is Avalon-ST x4, the

FPGA automatically downloads its configuration image from the QSPI flash device

connected to the FPGA's SDM interface. When the configuration is complete, green

LED (D12) illuminates signaling the device configured successfully. If the

configuration fails, D12 will not illuminate.

Send Feedback

can be damaged by power supplies with greater voltage.

Intel

™

Agilex

F-Series FPGA (Two F-Tiles) Development Kit User Guide

Table of Contents