Monitor On-Board Power Regulator Through Power Monitor Gui - Intel Agilex F Series User Manual

Import
ZL30733 has a multiple time writable non-volatile memory (NVM). You can generate
the register list with the following format:
• Register Write Command Line: X ,<register_address> , <data_bytes>—
<register_address> and <data_bytes>, whose prefix must be "0x" are in
hexadecimal
• Wait Command Line: W , <time_microseconds>
Import it into ZL30733 to update the settings of the NVM. Register changes are
volatile after power cycling. For more details, refer to
website.

4.4. Monitor On-Board Power Regulator through Power Monitor GUI

The Power Monitor GUI reports most power rails' voltage, current, and power
information on the board. It also collects temperature from FPGA die, power modules,
and diodes assembled on PCB.
The Power Monitor GUI communicates with system Intel MAX 10 through a 10-pin
JTAG header J3 or USB port J10. System Intel MAX 10 monitors and controls power
regulator, temperature/voltage/current sensing chips through a 2-wire I
The instructions to run Power Monitor GUI are stated in the Run BTS GUI section. It
can also be started with the BTS GUI icon "Power".
Note: You cannot run the stand-alone Power Monitor GUI when the BTS or the Clock
Controller GUI is running at the same time.
Figure 20. Power Monitor GUI
The following sections describe the details of the Power Monitor GUI.
® ™
Intel Agilex F-Series FPGA (Two F-Tiles) Development Kit User Guide
26
4. Board Test System
739942 | 2022.09.21
ZL30733 on the Microchip
2
C bus.
Send Feedback