Table of Contents
Advertisement
A. Development Kit Components
739942 | 2022.09.21
Power telemetry is provided via the Intel MAX 10 and I
voltage regulators and temperature sensors on the board. The power utilization is
displayed on a GUI that shows power consumption versus time.
A.11. Power Guidelines
The Intel Agilex FPGA development kit has two modes of operation.
A.11.1. In a Standard PCIe-Compliant System
In this mode, plug the board into an available PCI Express (PCIe) slot and connect the
standard 2 x 4 auxiliary power cord available from the PC's ATX power supply to the
respective mating power connector on the board (J11). The PCIe slot together with
the auxiliary PCIe power are required to power the entire board. If you do not connect
the 2 x 4 auxiliary power connections, the board will not power on when installed in a
PCIe system. The power switch SW5 is ignored when the board is used in the PCIe
system.
Figure 28.
In a Standard PCIe-Compliant System
A.11.2. As a Standalone Evaluation Board Powered by Included Power
Supply
In this mode, plug the included power supply into the 2 x 4 pin connector (J11) and
the AC power cord of the power supply into a power outlet.
Note:
The power supply connector is a 2 x 3 pin connector but is keyed to mate with 6 pins
of the J11 power input on the board.
This power supply provides the entire power to the board without the need to obtain
power from the PCIe slot. The power switch SW5 controls powering the board on or
off.
Send Feedback
PCIe Aux Power
Motherboard
PCIe Slot
®
™
Intel
Agilex
F-Series FPGA (Two F-Tiles) Development Kit User Guide
2
C interface to the various
ATX Power Supply
J11
67
Advertisement
Table of Contents
