Panasonic FP7 Series Command Reference Manual page 181

Hide thumbs Also See for FP7 Series:

Table of Contents

3.25 MC (Master Control Relay), MCE (Master Control Relay End)

1) DF (leading edge differential) instruction

2) Count input for CT (counter) instruction

3) Count input for UDC (up-down counter) instruction

4) Shift input for SR (shift register) instruction

5) Shift input for LRSR (left and right shift register) instruction

6) Differential execution type high-level instruction (instruction specified by p and instruction name)

Operation Example

Operation of differential instructions between MC and MCE

● If the differential instruction is used between MC and MCE, the output obtained differs

depending on the execution condition of MC and the input timing of the differential instruction

as shown below.

WUME-FP7CPUPGR-12