Section 7 - Repair Procedures
003
TABLE
Removing the engine from the machine
Procedure:
10 Disconnect the throttle control cable removing
the locking clip; remove the screws fixing
the rope sheath to the engine using a 10mm
combination wrench.
11 Close the oil tank cocks.
12 Disconnect the flexible hose of the silencer
removing the three nuts fixing the manifold to
the thermal engine using a 13mm wrench.
13 Remove the manifold.
14 Disconnect all the electrical wires connected to
the engine, and namely:
oil pressure bulb,
electrical stop,
water temperature bulb,
the three alternator connections,
starter motor,
ground between chassis and engine,
the two coils of the transmission pump solenoid
valve.
15 Disconnect the radiator:
•
tremove the clamps fixing the sleeves to the
radiator
•
disconnect the radiator hyraulic hoses using a
41mm combination wrench.
16 Remove the screw (C) of the bracket fixing
the radiator to the chassis, using two 13mm
combination wrench. Remove the screws of the
fan guard using a 13mm wrench, and remove
the nuts (D) of the vibration-damping brackets
using a 22mm wrench. Extract the radiator
using a bridle and a bridge crane, make sure do not
damnage the parts.
12
GTH-4017EX GTH-4514EX GTH-4013 EX
10
11
16
15
C
November 2008
003
Table:
GTH-4017EX
GTH-4514EX
GTH-4013EX
Document 57.0009.0427