Terex Genie GTH-4017 EX Service Manual page 54

Section 2 - Technical Specification
TECHNICAL SPECIFICATION
LIST OF THE DLE PARAMETERS
N° Winscope Name
00 C1cellaVuoto
01 C1cellaCarico
02 C1cellaMin
03 C1cellaMax
04 C2cellaVuoto
05 C2cellaCarico
06 C2cellaMin
07 C2cellaMax
08 Filter
09 paCellaUnica
10 Celle_MaxDelta
11 SpanForche
12 SpanNavicella
13 DeltaSpanGomme
14 OffSet0
15 OffSet1
16 paIsteresiSblocco
17 paRitardoSblocco
32
Description
Value saved in analog channel 1 - calibration with unloaded
machine (best setting around 700).
Value saved in analog channel 1 - calibration with loaded machine
(best setting around 300).
Min admissible value for analog channel 1 reading (if actual value
is below: alarm 2) (value set at 10 roughly).
Max admissible value for analog channel 1 reading (if actual value
is above: alarm 2) (value set at 1010).
Value save in analog channel 2 - calibration with unloaded machine
(best setting around 300).
Value save in analog channel 2 - calibration with loaded machine (best
setting around 700).
Min admissible value for analog channel 2 reading (if actual value is
above: alarm 3)(value set at about 10).
Max admissible value for analog channel 2 reading (if actual value is
above: alarm 3) (value set at about 1010).
Number of filter samples, with mobile mean. Load cell reading. Max
5.
Sets to 1 automatically (during the machine selection) when the DLE
is used in single channel mode.
Max admissible delta between readings of analog channels 1 and 2,
expressed as a %, default 10 (current 20).
Limiter intervention percentage in case of work with stabilised
machine and forks. Default: 100 (as per calibration).
Limiter intervention percentage in case of work with stabilised machine
and platform (changed by the relevant procedure during calibration).
When the platform is selected, the limiter uses this % (default 110%
- load increase of 10%) instead of the SpanForche datum (current
value 125).
Limiter intervention percentage in case of work with non-stabilised
machine (changed by the relevant procedure during calibration).
% value that adds to the calibration with forks and outriggers
(SpanForche).
Command given to the digital potentiometer for cell 1 (value
from 0 to 255) to set the reading scale during calibration with
unloaded machine to a certain pre-set value (about 900 bit ADC
- C1cellaVuoto) (about 700).
Command given to the digital potentiometer for cell 2 (value from 0 to
255) to set the reading scale during calibration with unloaded machine
to a certain pre-set value (about 200 bit ADC - C2cellaVuoto) (about
300).
Load % for the reset of the movements once the block condition
has been rectified. (default 5% = 95%).
Value expressed in tenths of second corresponding to the time
that must elapse between the block condition and the movement
reset (default 10 = 1 second).
GTH-4017EX GTH-4514EX GTH-4013EX
November 2008
Document 57.0009.0427