Terex Genie GTH-4017 EX Service Manual page 55

November 2008
20 C1NavicellaVuoto
21 C1NavicellaCarico
22 C2NavicellaVuoto
23 C2NavicellaCarico
24 CurMacchina
28 VersioneSW
29 WPsum
LIST OF THE DLE VARIABLES
N° Winscope Name
05 PCorder
10 C1swl
13 C1adcFiltro
Document 57.0009.0427
Parameters 20, 21, 22 and 23 are usually equivalent to parameters
0, 1, 4 and 5. They shall be used for a new calibration of the platform
not depending on the proportional % calibration done with the forks.
These parameters only apply to the platform. Value saved in analog
channel 1 during calibration with empty machine.
Value saved in analog channel 1 during calibration with loaded
machine.
Value saved in analog channel 2 during calibration with empty
machine.
Value saved in analog channel 2 during calibration with loaded
machine.
Machine selected on point "0" of the calibration.
Software version.
Parameters CHECKSUM used by the safety functions.
Default
0
GTH-4017EX GTH-4514EX GTH-4013EX
Section 2 - Technical Specification
Description
You can save changes effected to the
parameters by setting this variable to "1". The
variable will return to 0 once the value has
been saved.
Load percentage of cell 1 (0% = calibration
without load; 100% = calibration under load).
Current value of cell 1 (analog, converted into
bits 0 - 1023).
TECHNICAL SPECIFICATION
33