Terex Genie GTH-4017 EX Service Manual page 211

November 2008
Procedure: Renewing the slide pads of the telescopic boom
GTH-4017EX GTH-4514EX
RENEWING THE REAR PADS (A)
To renew the rear pads of the section, retract the
boom entirely and proceed as follows:
8 Stop the machine, lower the nose to the ground
for an easier removal of the top pads. Hold it for
removing the bottom pads.
9 Using a 17mm hex wrench or a 6mm Allen
wrench, remove the pad fixing screws.
10 Using a screwdriver, pry off the worn pads. Fit
new pads after applying a few drops of Loctite
495 on the threads.
CAUTION
Tighten the pad fixing screws to 30÷35 Nm.
RENEWING THE FRONT PADS (B)
To renew the front pads of the section, extend the
boom of about 1 meter, and proceed as follows:
11 Stop the machine, lower the nose to the ground
for an easier removal of the bottom pads. Hold
it for removing the top pads.
CAUTION
Tighten the pad fixing screws to 30÷35 Nm.
12 Using a 17mm hex wrench or a 6mm Allen
wrench, remove the pad fixing screws. Using a
screwdriver, pry off the worn pads. Fit new pads
after applying a few drops of Loctite 495 on the
threads.
Document 57.0009.0427 GTH-4017EX GTH-4514EX GTH-4013 EX
Section 7 - Repair Procedures
9 12
A
9 12
A
9 12
A
A
12
9
A
A
012
TABLE
012
Table:
GTH-4017EX
GTH-4514EX
GTH-4013EX
B
B
B
B
B
B
39