Table of Contents
Advertisement
Section 3 - Maintenance Inspections
MAINTENANCE INSPECTIONS
Within the first 50 working hours:
B-1
Check the general efficency of the machine.
Every 50 working hours or weekly:
B-2
Check the tension of the alternator belt.
B-3
Check the tyre inflation.
B-4
Check the tightening of the wheel nuts.
B-5
Check the tightening of the cardan shaft screws.
B-6
Clean the fins of radiator.
Within the first 100 working hours
C-1
Change the oil in the differential gears, in the four wheel reduction gears and in the power divider.
Every 250 working hours or monthly:
C-2
Change the engine oil and relevant filter
C-3
Check the oil level in the front and rear differential gears.
C-4
Check the oil level in the four wheel reduction gears.
C-5
Check the main filtering element of the engine air filter. Replace, if necessary.
C-6
Check the clamping of the cableheads to the battery terminals.
C-7
Check the air suction hose between engine and filter. Replace, if necessary.
C-8
Check the cylinder chromium-plated rods.
C-9
Check the hydraulic lines are not worn because of rubbing against the frame or other mechanical
components.
C-10
Check the electric cables do not rub against the frame or other mechanical components.
C-11
Check the wear of the sliding pads of the boom sections.
C-12
Adjust the play of the sliding pads of the boom sections.
C-13
Remove any grease from the boom, then re-grease the sliding parts of the boom sections.
C-14
Check the level of the battery electrolyte.
C-15
Check the efficiency of the block valves.
4
TABLE B
TABLE C
GTH-4017EX GTH-4514EX GTH-4013EX
November 2008
Document 57.0009.0427
Advertisement
Table of Contents
