Placing Into Operation; Starting The Machine - Terex PT60CE Operation And Maintenance Manual

2 SAFETY

2.13 Placing into Operation

• Every time before placing the machine into operation, perform a thorough
walk-around inspection of the machine.
• Check the machine for loose pins, cracks, tears, wear, leaks and deliberate
damage.
• Never place a damaged machine into operation.
• Make any necessary repairs immediately, prior to resuming operation.
• Inspect to make sure all warning signs are in place and legible, then close
and lock all hoods and covers,.
• Make sure all windows and mirrors are clean. Secure door and windows
against unintentional movements.
• Make certain no one is working on or under the machine and warn any
persons standing nearby that the machine will be placed into operation.
• Prior to placing the machine into operation, adjust the driver's seat, mirrors,
and ventilation system settings (if equipped) so you can work in comfort
and safety.

2.14 Starting the Machine

• Before starting, check all indicator lamps and instruments to make certain
they are working properly.
• Start the engine in the manner described in the operating instructions.
• Only allow the engine to run in enclosed rooms if there is adequate
ventilation. If necessary, open doors and windows to ensure a proper supply
of fresh air.
• Bring the engine and hydraulic oil up to operating temperature. Low oil tem-
peratures can cause the control system to respond sluggishly.
• Move the machine carefully to open ground and then check the functionality
of the lift arm and drive controls as well as the signal and lighting
equipment.
22