Table of Contents
Advertisement
November 2008
2.23
HYDROSTATIC
CONTROL UNIT CHECK SYSTEM
An electronic control unit gives power to the SAUER
hydrostatic transmission; the software PLUS+1 lets to
control the transmission.
•
Connect the computer to the cable CAN/USB (cod.
55.0602.0331).
•
Joint the cable (cod.
"DIAGNOSI SAUER" connector of the electric line.
•
Start the software "PLUS+1".
•
Turn ON the ignition key or start the engine.
•
Click on "+" and open the windows of system (image 1)
Proceed as follows:
•
FILE
•
OPEN
•
Choose the diagnostic file (image 1).
•
Select and click INVIO.
•
Click on "+" to open the dialog windows (image 2).
Check the installed SOFTWARE is right (image 3)::
•
Select SYSTEM
•
Select SYSTEM INFORMATION.
Check the customer specific is 401701 for GTH 4514EX
and for GTH 4017EX; 401301 for GTH 4013EX.
Open the first control system page:
•
Select SYSTEM.
•
Select ELECTRICAL.
The window (image 4) shows the electric input/output
of the system.
EXEMPLE:C1P06- input forward speed, C1P07- input
rear speed,
the electric input/output are colored refer to speed
(images 5 - 6).
It is possible to check the ROAD/JOB-SITE signal.
It is possible to check the windows are ON when the
ROAD/JOB-SITE push button on the dashboard is
pressed (C2P01 - C2P02)
Document 57.0009.0427
TRANSMISSION
55.0602.0491) to the
GTH-4017EX GTH-4514EX GTH-4013EX
Section 2 - Technical Specification
TECHNICAL SPECIFICATION
1
2
3
35
Advertisement
Table of Contents
