Rep 6.4 Hvps (1St/ 2Nd/ Dts) - Xerox Phaser 7500 Service Manual

REP 6.4 HVPS (1st/ 2nd/ DTS)

PL6.2.9
Phaser 7500 Printer Service Manual
Caution
PWB's can be damaged by an electrostatic discharge. Observe all ESD
procedures to avoid component damage.
1. Remove the PWB Chassis Unit (REP 18.10,
2. Disconnect the wiring harness connector that is connected to the HVPS (1st/
2nd/ DTS).
3. Remove 5 screws (silver, 8mm) that secure the HVPS (1st/ 2nd/ DTS) to the
printer.
4. Lower the right side of the HVPS (1st/ 2nd/ DTS) to release it from the spring
that is attached to the conductor, and slip off the HVPS (1st/ 2nd/DTS) holes
from the conductor shafts to remove the HVPS (1st/ 2nd/DTS).
HVPS
Service Parts Disassembly
page 8-197).
s7500-117
8-65