Adjustments and Calibrations
ADC Output Check
Procedure
6-6
The ADC Output Check allows the users to test the Automatic Density Correction
sensor and compare a target value in logic to the value seen by the individual
sensors.
Note
Data cannot be adjusted within this function. This is an information only.
1. Enter Service Diagnostics
2. Scroll down the menu and select Adjustments/ Calibrations. Press OK.
3. Select ADC Output Check and press OK.
4. The printer starts processing with a Reading ADC Data... message appears.
5. Review the results to ensure there are no failures.
6. Press any key to see more data.
(page
4-9).
Phaser 7500 Printer Service Manual