Error Messages and Codes
Drive Logic Fail
Applicable Chain-Link Code
Initial Actions
3-130
A fatal error was detected in Drive control.
•
045-312: Drive Logic Fail
•
Power cycle the printer.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
MCU PWB, PL18.3.6
■
1. Turn the power Off and On.
2. Install the correct version of the IOT firmware.
3. Restore NVRAM. If the problem persists, replace the MCU PWB (REP 18.12,
page
8-202).
Wiring and Plug/Jack Map References
Phaser 7500 Printer Service Manual