Net/ Usb System Fail - Xerox Phaser 7500 Service Manual

Hide thumbs Also See for Phaser 7500:

Table of Contents

Error Messages and Codes

NET/ USB System Fail

1. Check if the Controller ROM is the latest version. If it is not the latest, upgrade

the software.

2. Check the connection between the Image Processor Board and the Net to

install them securely, then turn the power On.

Check for faulty ports or Net connection. Check which of the following ports is

Salutation IO

After checking, perform the same operation where the error occurred. If the

problem persists, obtain the "info9 or xxx.tgz" log using the log tool.

3. If the problem persists, reinstall or replace the RAM DIMM and then turn the

power On. Perform the same operation where the error occurred.

4. If the problem persists, replace the Image Processor Board (REP 35.1,

8-220) since it may be faulty. Perform the same operation where the

error occurred.

5. If the system is not restored after the Image Processor Board has been

replaced, reinstall the original Image Processor Board.

6. Return the NVM that was set to "1".

Phaser 7500 Printer Service Manual