Tray 5 Feed Out Sensor Static Jam - Xerox Phaser 7500 Service Manual

Tray 5 Feed Out Sensor Static Jam

Phaser 7500 Printer Service Manual
When the power was turned On, the M/C was stopped (Cycle Down/ Shut Down),
or when the interlocks were closed (all interlocks including options), the Tray 5 Feed
Out Sensor detected paper.
Applicable Chain-Link Code
• 074-900: IOT Static Jam (at Tray 4 Feed Out Sensor)
Initial Actions
• Check the paper path for debris.
• Power cycle the printer.
• If the problem persists, follow the procedure below.
Troubleshooting Reference
Applicable Parts
Tray Module PWB, PL10.9.1
■
MCU PWB, PL18.3.6
■
Motor Drive PWB, PL18.3.7
■
TM Relay PWB, PL18.3.11
■
1. Check the Tray 5 Feed Out Sensor for remaining paper, contamination,
Actuator return failure, or improper installation.
2. Perform the Tray Feed Sensors test in Diagnostics.
3. Check the connection between the Tray 5 Feed Out Sensor J116-2 and the
Tray Module PWB J548-2 for short circuit.
4. Check the connection between the Motor Drive PWB J509-8 and the TM Relay
PWB J801-8 for short circuit.
5. Check the connection between the TM Relay PWB J800-B7 and the Tray
Module PWB J541-8 for short circuit.
6. If no problems are found, replace the following parts in sequence:
• Tray Module PWB (REP 10.9,
• TM Relay PWB (REP 18.14,
• Motor Drive PWB (REP 18.13,
• MCU PWB (REP 18.12,
Error Messages and Codes
Wiring and Plug/Jack Map References
page 8-97)
page 8-205)
page 8-204)
page 8-202)
3-45