Table of Contents
Advertisement
3 Startup Procedure and Test Run
3.
Push
or
to select [Monitors], then push
4.
Push
or
to select [Custom Monitor], then push
5.
Push
or
to select [Custom Monitor 1], then push
6.
Push
or
to select the monitor number to register, then push
Enter the three digits in "x-xx" part of monitor Ux-xx to identify which monitor to output. For example, to
show monitor U1-05, set it to "105" as shown in this figure.
The configuration procedure is complete.
■
Show Custom Monitors
The procedure in this section shows how to show the registered custom monitors.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
(Menu).
126
.
, push
(Back) to show [Home] on
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
(Setup).
.
.
.
Advertisement
Table of Contents
