Table of Contents
Advertisement
3.
Push
or
to select [Display Monitor], then push
4.
Push
or
to select [Display Bar Graph], and push
The screen will show the monitors as shown in this figure.
■
Set the Monitors to Show as Analog Gauges
The procedure in this section shows how to show the frequency reference monitor as an analog gauge.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
(Menu).
3.
Push
or
to select [Monitors], then push
4.
Push
or
to select [Analog Gauge], then push
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
, push
(Back) to show [Home] on
.
3 Startup Procedure and Test Run
.
.
.
(Setup).
129
Advertisement
Table of Contents
