Table of Contents
Advertisement
◆
Removing/Reattaching Covers
This section gives information about how to remove and reattach the front cover and terminal cover for wiring
and inspection.
Different drive models have different procedures to remove and reattach the covers. Refer to Table 2.7 for details.
Model
2003 - 2180
4002 - 4150
2215 - 2415
4180 - 4605
■
Removing/Reattaching the Cover Using Procedure A
DANGER
Electrical Shock Hazard. Do not examine, connect, or disconnect wiring on an energized drive. Before
servicing, disconnect all power to the equipment and wait for the time specified on the warning label at a minimum. The internal
capacitor stays charged after the drive is de-energized. The charge indicator LED extinguishes when the DC bus voltage
decreases below 50 Vdc. When all indicators are OFF, remove the covers before measuring for dangerous voltages to make
sure that the drive is safe. Failure to obey will cause death or serious injury.
Remove the Front Cover
1.
Remove the keypad and remove the keypad connector, then insert the end of the keypad connector that
has the tab into the keypad connector holder on the front cover.
A - Keypad
B - Keypad connector
2.
Loosen the front cover screw.
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
Table 2.7 Procedures to Remove Covers by Drive Model
C - Holder
Figure 2.20 Remove the Keypad and Keypad Connector
Figure 2.21 Loosen the Front Cover Screw
2 Mechanical & Electrical Installation
Procedure
Procedure A
Procedure B
35
Advertisement
Table of Contents
