Table of Contents
Advertisement
3 Startup Procedure and Test Run
4.
Push
or
to select [C Tuning], then push
5.
Push
or
to select [C1 Accel & Decel Time], then push
6.
Push
or
to select C1-01, then push
7.
Push
or
to select the specified digit, then push
• Push
[Default] to set the parameters to factory defaults.
• Push
[Min/Max] to show the minimum value or the maximum value on the display.
8.
Push
to keep the changes.
9.
Continue to change parameters, then push
all the applicable parameters.
■
Examine User Custom Parameters
The User Custom Parameters show the parameters set in A2-01 to A2-32 [User Parameter 1 to User Parameter
32]. This lets users to quickly access and change settings to these parameters.
Note:
The User Custom Parameters always show A1-06 [Application Selection] at the top of the list. The A2-01 to A2-32 settings change when
the A1-06 setting changes, which makes it easier to set and reference the necessary parameter settings.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
136
.
.
[Back] to go back to the home screen after you change
, push
(Back) to show [Home] on
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
.
or
to select the correct number.
.
Advertisement
Table of Contents
