Table of Contents
Advertisement
3 Startup Procedure and Test Run
2.
Push
(Menu).
3.
Push
or
to select [Initial Settings], then push
4.
Push
or
to select [Language Selection], then push
5.
Push
or
to select the language, then push
The procedure to set the keypad language is complete.
■
Set the Date and Time
The procedure in this section shows how to set the date and time.
Note:
• Refer to Replace the Keypad Battery on page 393 for information about the battery installation procedure.
To set the drive to detect an alarm when the battery is dead or when the clock is not set, install the battery then set o4-24 = 1 [bAT
Detection selection = Enable (Alarm Detected)].
• If the keypad does not have a clock battery, you must set the date and time each time you energize the drive.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
2.
Push
(Menu).
148
, push
(Back) to show [Home] on
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
.
.
.
.
Advertisement
Table of Contents
