Table of Contents
Advertisement
A - Front of drive
3.
Align the screw holes on conduit bracket 2 with the screw holes on conduit bracket 1.
Tighten the screws to a tightening torque of 0.98 N∙m to 1.33 N∙m (8.67 lb.∙in. to 11.77 lb.∙in.).
A - Conduit bracket 2
◆
Installation Procedure
The drive installation methods include standard installation and panel-through mounting.
■
Standard Installation
Refer to Drive Exterior and Mounting Dimensions on page 405 for more information about external dimensions
and installation procedures.
■
Panel-through Mounting
Refer to Table 2.9 and Table 2.10 for the panel cut out dimensions for installations in which the heatsink is
external to the drive. The drive models smaller than 2075 and 4045 require an attachment for panel-through
mounting.
Note:
• The mounting exterior dimensions and installation dimensions for a standard installation can differ from those of a panel-through
mounting.
• The shaded parts of the panel cut out dimensions are the gasket dimensions. Check the above mentioned dimensions for gasket width.
Make sure that the gasket is not smaller than the specified size.
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
B - Screw holes on bottom
Figure 2.65 Locations of Screw Holes on Bottom
Figure 2.66 Attach Conduit Bracket 2
2 Mechanical & Electrical Installation
51
Advertisement
Table of Contents
