Table of Contents
Advertisement
8.
When the keypad shows the Auto-Tuning start screen, push
Auto-Tuning starts.
When doing Rotational Auto-Tuning, the motor will stay stopped for approximately one minute with power
energized and then the motor will start to rotate.
9.
When the keypad shows this screen after Auto-Tuning is complete after 1 or 2 minutes, push
The keypad will show a list of the changed parameters as the result of Auto-Tuning.
10.
Push
or
in the parameter change confirmation screen to check the changed parameters, then
select [Auto-Tuning Successful] at the bottom of the screen and push
To change a parameter again, push
Parameter Setting screen.
Auto-Tuning is complete.
Note:
If you push
or the drive detects an error before Auto-Tuning is complete, the keypad will show an error code and Auto-Tuning
will stop. The keypad shows an "Endx" error when Auto-Tuning has successfully completed with discrepancies in the calculations. Find
and repair the cause of the error and do Auto-Tuning again, or set the motor parameters manually. The drive may be used in the
application if no cause can be identified despite the existence of an "Endx" error. The keypad shows Er-xx when Auto-Tuning has not
completed successfully. Find and repair the cause of the error and do Auto-Tuning again.
■
Set the Keypad Language Display
The procedure in this section shows how to set the language shown on the keypad.
1.
Push
(Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
or
to select the parameter to change then push
, push
(Back), to show [Home] on
3 Startup Procedure and Test Run
.
.
.
or
.
to show
147
Advertisement
Table of Contents
