Select Output Signals For Multi-Function Analog Output Terminals Fm, Am; Switch On Termination Resistor For Memobus/Modbus Communications; Connect The Drive To A Pc - YASKAWA CIPR-CR70A Series Technical Manual

Use DIP switch S4 to select the input function.
Settings for DIP
Terminal
A3
■

Select Output Signals for Multi-Function Analog Output Terminals FM, AM

The signal level for the voltage output of terminals AM and FM can be set. Set using H4-07 and H4-08.
Types of Output
Terminal
FM Voltage output
AM Voltage output
■

Switch ON Termination Resistor for MEMOBUS/Modbus Communications

Set DIP switch S2 to the ON position when the drive is the last slave in a MEMOBUS/Modbus communications.
This drive is equipped with a built-in termination resistor for the RS-485 interface.
Table 2.23 MEMOBUS/Modbus Communications Termination Resistor Setting
DIP Switch S2
ON
OFF (default)
◆

Connect the Drive to a PC

The drive has a mini-B type USB port.
YASKAWA ELECTRIC SIEP C710617 19A YASKAWA AC Drive CR700 Technical Manual
Figure 2.116 Location of DIP Switch S4
Switches
Functions as multi-function analog input terminal.
Select the function with H3-06 [Terminal A3 Function Selection].
AI
Select the signal level with H3-05 [Terminal A3 Signal Level Select].
(Default)
• 0: 0 V to 10 V/100% (input impedance: 20 kΩ)
• 1: -10 V to +10 V/-100% to +100% (input impedance: 20 kΩ)
Functions as PTC input terminal.
PTC Set H3-06 = E [Motor Temperature (PTC input)].
Set H3-05 = 0 [0 to 10 V].
Signals
No.
H4-07
[Terminal FM Signal
Level Select]
H4-08
[Terminal AM Signal
Level Select]
Figure 2.117 Location of DIP Switch S2
The built-in termination resistor is switched ON.
The built-in termination resistor is switched OFF.
2 Mechanical & Electrical Installation
Description
Parameters
Signal Level
0: 0 to 10 Vdc (default)
1: -10 to +10 Vdc
0: 0 to 10 Vdc (default)
1: -10 to +10 Vdc
Description
97