Selecting A Job To Build - Stratasys FDM Vantage Series User Manual

Operating the Machine

Selecting a Job to Build

1. From the Main Menu select Build Job and press ENTER.
>Build Job..
Operator Control..
Modeler Status..
Maintenance..
2. Select from one of the following:
• Build Next Job, Build Last Job, Show Job Queue, or Show Sample Job Queue
>Build Next Job:
Build Last Job:
Show Job Queue..
Show Sample Job Queue..
* Job: motor housing (Building)
* Build Time: 0:01 hr of 0:02 hr
* ABS
* Modeler Status..
Building the Next Job
After a job has been built, use the following steps to build the next job:
1. Remove the part(s) from the oven and change the build sheet.
2. Verify that the vacuum gauge reads -15 or higher.
3. From the Main Menu select Build Job and press ENTER.
4. Select Build Next Job and press ENTER. The platen moves into position, the
head heats up, material purges, and the head performs a tip wipe.
Building the Last Job
To build the last job that was built:
1. From the Main Menu select Build Job and press ENTER.
2. Select Build Last Job and press ENTER.
The previous job built by the machine will show on the screen. If no previous job
was built, the screen will show No Previous Job.
Building a Specific Job in the Queue (Show Job Queue):
1. From the Main Menu select Build Job and press ENTER.
2. Select Show Job Queue and press ENTER.
5 - 6
motor housing <E>
rotor <E>
0.1 in3 ABS_SS
FDM Vantage User Guide
|*Tips: Model T16
|* Support T16
(6 Jobs)
0.1 Mode:Normal
0.010 of 0.950 in