Front panel
▶ Remove the front VGA cable from the cable clip (see circle).
▶ Disconnect the front VGA cable from the system board connector "Front
VGA" and remove it.
Installing the dummy cover
Figure 244: Installing the dummy cover
▶ Install the dummy cover.
Concluding steps
▶
"Installing the air duct" on page
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
14.4.3
Replacing the front VGA
Upgrade and Repair Unit
(URU)
Tools:
– Phillips PH2 / (+) No. 2 screw driver (for cover 2)
– hexagon screw driver 5 mm (for front VGA)
334
74.
57.
62.
66.
Upgrade and Maintenance Manual
66.
Hardware: 5 minutes
RX2530 M6