Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
1. Check Enable checkbox to enable the Fixed Region function.
2. Select a stream type. You can set the ROI function for main stream, sub stream or third
stream.
3. Click
and then click-and-drag the mouse to draw a red frame in the live
view image. You can click
The number of areas supported in ROI function varies depending on the models of
positioning system.
4. Select the Region No. from the dropdown list.
5. Adjust the ROI level from 1 to 6. The higher the value, the better image quality in the red
frame.
6. Enter a Region Name.
ROI for Dynamic Region
Check Enable Face Tracking checkbox to enable face tracking, and the captured face
1.
picture is set as region of interest. Adjust the ROI level from 1 to 6.
Check Enable Target Tracking checkbox to enable target tracking, and the target is
2.
set as region of interest. Adjust the ROI level from 1 to 6.
Click Save to save the settings.
3.
This function varies according to models.
7.3 PTZ Configuration
On the event configuration page, click
hide it.
Click the direction buttons to control the pan/tilt movements.
Click the zoom/iris/focus buttons to realize lens control.
The functions vary depending on the models of positioning system.
7.3.1 Configuring Basic PTZ Parameters
Purpose:
You can configure the basic PTZ parameters, including proportional pan, preset freezing,
preset speed, etc.
1. Enter the Basic PTZ Parameter Configuration interface:
© Hikvision
to clear it.
to show the PTZ control panel or click
94
to
Advertisement
Table of Contents
