Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
(1) Click Draw Area. Click the mouse on the live video image to draw a ship
detection area and right click to finish the drawing. The alarm will be
uploaded when ship is detected in this area.
(2) Click Draw Alarm Line. Click the mouse on the live video to draw an alarm
line and right click to finish the drawing. The device alarms and counts the
ship number when ships are detected in the area and the ship information
will be displayed on the right.
Make sure the alarm line is longer than the width of ship detection area.
7. Check the checkbox to select the linkage method taken for the alarm input. Refer to
Step 3 in Section 5.2.1 Configuring Motion Detection. In the field of Other Linkage, you
can check the checkbox to enable the alarm output (The alarm output number varies
depending on device ability).
8. Click
5.4 Temperature Measurement
Purpose:
When you enable this function, it measures the actual temperature of the spot being
monitored. The device alarms when temperature exceeds the temperature threshold
value.
Before You Start:
Enter Configuration > Advanced Configuration > System > VCA Resource Type to select
Temperature Measurement + Behavior Analysis as VCA Resource Type.
5.4.1 Temperature Measurement Configuration
Steps:
1. Enter Configuration > Temperature Measurement > Basic Settings Configuration.
© Hikvision
to save the settings.
58
Advertisement
Table of Contents
