Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
(1) Check the radio button to enable the NTP function.
(2) Configure the following settings:
Server Address: IP address of NTP server.
NTP Port: Port of NTP server.
Interval: The time interval between the two synchronizing actions by NTP server. It
can be set from 1 to 10080 minutes.
You can click
If the positioning system is connected to a public network, you should use a NTP
server that has a time synchronization function, such as the server at the National
Time Center (IP Address: 210.72.145.44). If the positioning system is set in a
customized network, NTP software can be used to establish a NTP server for time
synchronization.
Configuring Time Synchronization Manually
Steps:
(1) Check the Manual Time Sync radio button.
(2) Click
to set the system time from the pop-up calendar.
(3) Click
You can also check the Sync with local time checkbox to synchronize the time of the
positioning system with the time of your computer.
© Hikvision
Figure 7-60 Time Sync by NTP Server
to make sure that the NTP server is connected.
to save the settings.
Figure 7-61 Time Sync Manually
120
Advertisement
Table of Contents
