Configuring Fire And Smoke Detection - HIKVISION DS-2TD8166-180ZE2F-V2 User Manual

User Manual of Thermal Network Positioning system
5. Click
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
6. Click
exception, Notify Surveillance Center, Send Email, Trigger Alarm Output and Trigger
Recording are selectable. Refer to Section 5.2.1 Configuring Motion Detection.
7. Click

5.3.2 Configuring Fire and Smoke Detection

Purpose:
When you enable this function and fire source or smoke is detected, the alarm actions will
be triggered. You can set different detection mode, fire source zoom mode, and so on.
Steps:
1. Enter Configuration>Advanced Configuration>System>VCA Resource Type to select
Fire and Smoke Detection as VCA Resource Type.
2. Enter the fire and smoke detection interface:
Configuration > Event > Smart Event > Dynamic Fire and Smoke Detection
3. Check the checkbox of Enable Fire and Smoke Detection to enable the fire and smoke
detection function.
© Hikvision
tab to enter the arming schedule setting interface. The time
tab to select the linkage method taken for the audio input
to save the settings.
Figure 5-21 Fire and Smoke Detection
52