Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
2.
Click the checkbox of Enable Limit and choose the limit type as manual stops or scan
stops.
Manual Stops:
When manual limit stops are set, you can operate the PTZ control panel manually
only in the limited surveillance area.
Scan Stops:
When scan limit stops are set, the random scan, frame scan, auto scan, tilt scan,
panorama scan is performed only in the limited surveillance area.
Manual Stops of Limit Type is prior to Scan Stops. When you set these two limit types
at the same time, Manual Stops is valid and Scan Stops is invalid.
3.
Click the PTZ control buttons to find the left/right/up/down limit stops; you can also
call the defined presets and set them as the limits of the positioning system.
4.
Click Set to save the limits or click Clear to clear the limits.
7.3.3 Configuring Initial Position
Purpose:
The initial position is the origin of PTZ coordinates. It can be the factory default initial
position. You can also customize the initial position according to your own demand.
Customize an Initial Position:
Steps:
1.
Enter the Initial Position Configuration interface:
Configuration > PTZ > Initial Position
© Hikvision
Figure 7-27 Configure the PTZ Limit
97
Advertisement
Table of Contents
