Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
If you have no router but only a modem, you can use Point-to-Point Protocol over Ethernet
(PPPoE) function.
Steps:
1. Enter the
PPPoE settings interface:
Configuration > Network > Basic Settings > PPPoE
2. Check the Enable PPPoE checkbox to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
The User Name and Password should be assigned by your ISP.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including upper case letters, lower case letters, numbers
and special characters) in order to increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
4. Click
Configuring Port Settings
Purpose:
If there is a router and you want to access the positioning system through Wide Area
Network (WAN), you need to forward the 3 ports for the positioning system.
Steps:
1. Enter
the Port settings interface:
Configuration > Network > Basic Settings > Port
© Hikvision
Figure 7-7 PPPoE Settings
to save and exit the interface.
Figure 7-8 Port Settings
80
Advertisement
Table of Contents
