Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
Figure 2-11 Accessing the Positioning system with Static IP Directly
2.2.2 Dynamic IP Connection
Before you start:
Please apply a dynamic IP from an ISP. With the dynamic IP address, you can connect the
network positioning system to a modem or a router.
Connecting the network positioning system via a router
Steps:
1. Connect the network positioning system to the router.
2. In the positioning system, assign a LAN IP address, the subnet mask and the gateway.
Refer to Section 2.1.2 for detailed LAN configuration.
3. In the router, set the PPPoE user name, password and confirm the password.
For your privacy and to better protect your system against security risks, we
strongly recommend the use of strong passwords for all functions and network
devices. The password should be something of your own choosing (using a
minimum of 8 characters, including upper case letters, lower case letters, numbers
and special characters) in order to increase the security of your product.
Proper configuration of all passwords and other security settings is the
responsibility of the installer and/or end-user.
4. Set port mapping. E.g. 80, 8000 and 554 ports. The steps for port mapping vary
depending on different routers. Please call the router manufacturer for assistance with
port mapping.
5. Apply a domain name from a domain name provider.
6. Configure the DDNS settings in the setting interface of the router.
7. Visit the positioning system via the applied domain name.
Connecting the network positioning system via a modem
Purpose:
This positioning system supports the PPPoE auto dial-up function. The positioning
system gets a public IP address by ADSL dial-up after the positioning system is connected
to a modem. You need to configure the PPPoE parameters of the network positioning
system. Refer to Section 7.1.1 Configuring PPPoE Settings for detailed configuration.
© Hikvision
11
Advertisement
Table of Contents
