Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
Set the
2.
HTTP port, RTSP port and port of the positioning system.
HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
Server Port: The default port number is 8000.
3.
Click
Configuring NAT (Network Address Translation) Settings
Purpose:
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility
among networking equipment, software and other hardware devices. The UPnP protocol
allows devices to connect seamlessly and to simplify the implementation of networks in
the house and corporate environments.
With the function enabled, you don't need to configure the port mapping for each port, and
the camera is connected to the Wide Area Network via the router.
Steps:
1.
Enter the UPnP™ settings interface.
Configuration >Network > Basic Settings > NAT
2.
Check the checkbox to enable the UPnP™ function.
You can edit the Friendly Name of the positioning system. This name can be detected
by corresponding device, such as a router.
3.
Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
And you can customize the value of the port number by yourself.
4.
Click
© Hikvision
to save the settings.
Figure 7-9 Port Mapping Mode
to save the settings.
81
Advertisement
Table of Contents
