Configuring Capture Schedule - HIKVISION DS-2TD8166-180ZE2F-V2 User Manual

User Manual of Thermal Network Positioning system
the recording schedule, you have to set the Alarm Type and check the checkbox of
Trigger Channel in the Linkage Method of Alarm Input settings interface. For
detailed information, please refer to Section Alarm Input.
Record Triggered by Motion & Alarm: If you select Motion & Alarm, the video will

be recorded when the motion and alarm are triggered at the same time. Besides
configuring the recording schedule, you have to configure the settings on the
Motion Detection and Alarm Input settings interfaces.
Record Triggered by Motion | Alarm: If you select Motion | Alarm, the video will be

recorded when the external alarm is triggered or the motion is detected. Besides
configuring the recording schedule, you have to configure the settings on the
Motion Detection and Alarm Input settings interfaces.
Record Triggered by VCA events: If you select VCA, the video will be recorded

when the either of the VCA events is triggered. Besides configuring the recording
schedule, you have to configure the settings on the VCA interface.
VCA function varies depending on the models of positioning system.
Record Triggered by Event: If you select to record by event, the video will be

recorded when any of the events is triggered.
6. Click

5.1.2 Configuring Capture Schedule

Purpose:
You can configure the scheduled snapshot and event-triggered snapshot. The captured
picture can be stored in the local storage or network storage.
Steps:
1. Enter the Snapshot settings interface:
Configuration > Storage > Storage Settings > Capture
© Hikvision
to save the settings.
37