Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
5.2.4 Configuring Alarm Output
Steps:
1. Enter the Alarm Output settings interface:
Configuration> Event > Basic Event > Alarm Output
2. Select one alarm output channel in the Alarm Output dropdown list.
3. Set a name in
(optional).
4. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or Manual.
The delay time refers to the time duration that the alarm output remains in effect after
alarm occurs.
5. Click
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to Section 5.2.1 Configuring Motion Detection.
6.
You can copy the settings to other alarm outputs.
7.
Click
© Hikvision
tab to enter the arming schedule setting interface. The time
Figure 5-18 Alarm Output Settings
to save the settings.
49
for the alarm output
Advertisement
Table of Contents
