Chapter 2 Network Connection; Setting The Network Positioning System Over The Lan; Wiring Over The Lan - HIKVISION DS-2TD8166-180ZE2F-V2 User Manual

User Manual of Thermal Bi-spectrum Network Positioning System

Chapter 2 Network Connection

Before you start:
If you want to set the network positioning system via a LAN (Local Area Network),

please refer to Section 2.1.
If you want to set the network positioning system via a WAN (Wide Area Network),

please refer to Section 2.2.
2.1 Setting the Network Positioning system over
the LAN
Purpose:
To view and configure the positioning system via a LAN, you need to connect the network
positioning system in the same subnet with your computer, and install the SADP or client
software to search and change the IP of the network positioning system.
For the detailed introduction of SADP, please refer to Appendix.

2.1.1 Wiring over the LAN

The following figures show the two ways of cable connection of a network positioning
system and a computer:
Purpose:
To test the network positioning system, you can directly connect the network

positioning system to the computer with a network cable as shown in Figure 2-1.
Refer to the Figure 2-2 to set the network positioning system over the LAN via a

switch or a router.
PT Camera
© Hikvision
Network Cable
Figure 2-1 Connecting Directly
4