User Manual of Thermal Network Positioning system
2. Set the RS-485 parameters and click
The Baud rate, PTZ Protocol and PTZ Address parameters of the positioning system
should be exactly the same as those of the control device.
7.5.2 Maintenance
Upgrade & Maintenance
Rebooting the Positioning system
Steps:
1.
Enter the Maintenance interface:
2.
Configuration > System > Maintenance > Upgrade & Maintenance:
3.
Click
Restoring Default Settings
Steps:
1.
Enter the Maintenance interface:
Configuration > System > Maintenance > Upgrade & Maintenance:
2. Click
Clicking
the IP address and user information. Please use this button with caution.
© Hikvision
Figure 7-64 RS-485 Settings
to reboot the network positioning system.
or
restores all the parameters to default settings including
to save the settings.
to restore the default settings.
122