Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
Up to 8 NAS disks can be connected to the positioning system.
To initialize and use the memory card after insert it to the positioning system, please
refer to the steps of NAS disk initialization
5.2 Basic Event Configuration
Purpose:
This section explains how to configure the network positioning system to respond to
alarm events, including motion detection, video tampering alarm input, alarm output and
exception. These events can trigger the alarm actions, such as Send Email, Notify
Surveillance Center, etc.
For example, when motion detection is triggered, the network positioning system sends a
notification to an e-mail address.
On the event configuration page, click
hide it.
Click the direction buttons to control the pan/tilt movements.
Click the zoom/iris/focus buttons to realize lens control.
The functions vary depending on the models of positioning system.
5.2.1 Configuring Motion Detection
Purpose:
Motion detection is a feature which can trigger alarm actions and actions of recording
videos when the motion occurred in the surveillance scene.
Steps:
1.
Enter the motion detection setting interface:
Configuration > Event > Basic Event > Motion Detection
2.
Select the channel to set the motion detection.
3.
Check the checkbox of the Enable Motion Detection to enable this function.
© Hikvision
Figure 5-8 Quota Settings
to show the PTZ control panel or click
41
to
Advertisement
Table of Contents
