Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
2. Click the PTZ control buttons to find the area you want to shield from the smoke
detection.
3. Click Draw Area and drag the mouse in the live video window to draw the area.
4. You can drag the corners of the red rectangle area to change its shape and size.
5. Click Stop Drawing to finish drawing or click Clear All to clear all of the areas you set
without saving them.
6. Set the value of Active Zoom Ratio on your demand, and then the shield will only
appear when the zoom ratio is greater than the predefined value.
7. Click Add to save the smoke detection shield, and it will be listed in the Smoke
Detection Shield List area; you can select a region and click Delete to delete it from
the list; you can also define the color of the regions.
8. Check the checkbox of Enable Smoke Detection Shield to enable this function.
You are allowed to draw up to 24 areas on the same image.
The smoke detection shield function is reserved
9. Click
5.3.5 Ship Detection
Purpose:
When you enable this function and ship is detected, the alarm actions will be triggered.
Steps:
1. Enter Configuration>Advanced Configuration>System>VCA Resource Type to select
Ship Detection as VCA Resource Type.
2. Enter the ship detection interface:
Configuration > Advanced Configuration > Smart Event > Ship Detection
© Hikvision
to save the settings.
56
Advertisement
Table of Contents
