Table of Contents
Advertisement
User Manual of Thermal Network Positioning system
Displacement Constraint for Target Generation: Range [0-4], the higher the value is,
the slower the target is generated, and the higher accuracy the analysis will get.
Light Change Suppression: Check the checkbox to suppress the impact caused by
the illumination change.
Leave Interference Suppression: Check this checkbox to stop the interference caused
by the leaves in the configured area.
Scene Modes: The scene mode is set to be General by default. Select Distant View
when you are far from the targets. Select Indoor when you are indoor.
Optical-axis Movement: Check the checkbox when the target moves in the direction
of camera's optical -axis.
3. Adjust the Tracking Parameters.
Post-Tracking: Range [2-600], you can configure the tracking duration after the target
is still.
Force Tracking: Check the checkbox to enable the function to prevent the object to be
blocked. After the function being enabled, the positioning system will continue locating
and tracking the blocked target.
Restore Default: Click Restore to restore the parameters to the default.
Restart VCA: Click Restart to restart the VCA function.
6.3 Behavior Analysis
Purpose:
The positioning system supports patrol tracking for multiple scenes. At most 8 rules can
be configured for a single scene. You can configure the rules for the scene on your
demand.
Steps:
1. Configure the VCA Info: For details, see 7.2 Configuring VCA Information.
2. Configure the Zooming Ratio parameters: Set the appropriate tracking zooming ratio
with the PTZ control panel. Click on
The optical camera will track the target when the VCA rule is triggered which is
configured on the thermal camera.
© Hikvision
to save the settings.
67
Advertisement
Table of Contents
