Configuring For Hp-Ux - Intermec EasyLan AW02 User Manual

Configuring for HP-UX

EasyLAN Wireless User's Manual
For example :
LabelPrinter:\
:lp=:\
:rm=IMC:\
:rp=BINARY_P1:\
:sd=/usr/spool/LabelPrinter:
where:
LabelPrinter is the queue name.
IMC matches the name in the hosts file.
BINARY_P1 is the EasyLAN Wireless service name. Use TEXT_P1
instead of BINARY_P1 for text files.
sd is the spool directory.
3 Create the spool directory. The
the /usr/spool directory. To create a new spool directory, use the
command. For example:
mkdir /usr/spool/lpd/LabelPrinter
4 Print using the standard
lpr –PLabelPrinter filename
5 For AT&T based UNIX systems, such as SCO, use the standard
command:
lp –dLabelPrinter filename
Note: The configuration for HP Distributed Print Services and for earlier
versions of HP-UX is slightly different than described in this section.
1 Start the SAM program in GUI mode.
2 Double-click Printers and Plotters.
3 Double-click HP Distributed Printer Services.
4 Double-click Physical Printer.
5 From the Actions menu, select Add Physical Printer with Network
Interface. A form appears.
6 In the Supervisor field, enter any name, such as
7 If you have not already created the printer name, which is the name of
the print queue, you must perform these steps:
a Open a different terminal or console.
b Open the HOSTS file (located in /etc/hosts).
Chapter 2 — Configuring EasyLAN Wireless
spool directory is usually located in
lpd
command:
lpr
mkdir
lp
.
print
61