Starting Easylan Wireless - Intermec EasyLan AW02 User Manual

Starting EasyLAN Wireless

EasyLAN Wireless User's Manual
Note: The EasyLAN Wireless console-only serial port requires these
settings.
4 After you click Finish to exit EasyLAN Network Setup, you can start
EasyLAN Wireless and print test labels. For help, see the next sections,
"Starting EasyLAN Wireless" and "Printing Test Labels."
When you turn on the printer with EasyLAN Wireless, EasyLAN Wireless
goes through the following startup sequence.
1 EasyLAN Wireless runs through a set of power-up diagnostics for a few
seconds:
• If EasyLAN Wireless is operating properly, the yellow and green
LEDs blink momentarily and go out, and then the orange LED
remains on.
• If there is a problem, the orange LED blinks continuously in a regular
pattern. Try unplugging the power to the printer and then plugging
it in again. If the problem persists, contact your local Intermec
representative.
2 When the EasyLAN Wireless successfully connects to another wireless
device, the yellow and green LEDs remain on.
3 When wireless network data is received, the yellow and green LEDs
blink.
Review of the EasyLAN Wireless LEDs
Chapter 1 — Installing EasyLAN Wireless
Orange LED
Green LED
Yellow LED
13