Tcp/Ip Parameters Defined - Intermec EasyLan AW02 User Manual

TCP/IP Parameters Defined

Parameter Definition
TCP/IP Enable or disable TCP/IP communications.
If you disable TCP/IP communications, the EasyLAN
Wireless cannot communicate with the network.
Enabled Services Configure the services on the port you are using. For
help, see "Configuring the Port Services" on page 49.
Applications Select the protocols you want enabled.
Enabled
IP Address Enter the IP address for EasyLAN Wireless.
If you change the IP address and reset EasyLAN
Wireless to make the changes effective immediately,
you have to enter the new IP address in the
Address/Go to field of your browser to get the web
browser interface back.
Subnet Mask Enter the subnet mask.
Gateway Enter the IP address for the gateway or router.
Boot Method Select the method for setting the EasyLAN Wireless
TCP/IP parameters when the printer turns on or
EasyLAN Wireless is reset:
•
AUTO sets EasyLAN Wireless to try to get an IP
address using DHCP, BOOTP, and RARP. If it
cannot get an IP address using these methods,
AUTO changes to STATIC.
•
DHCP sets EasyLAN Wireless to use a DHCP
server to get its TCP/IP parameters.
•
BOOTP sets EasyLAN Wireless to use the boot
protocol to get an IP address.
•
RARP sets EasyLAN Wireless to use the reverse
address resolution protocol to get an IP address.
•
STATIC sets EasyLAN Wireless to use the static
TCP/IP parameters (IP address, subnet mask,
gateway IP address, and so on).
Boot Tries Enter the number of times the AUTO, DHCP,
BOOTP, or RARP boot method tries to set the
TCP/IP parameters before it uses static values.
EasyLAN Wireless User's Manual
7 You can click any of the commands along the left side of the page. To
exit, click Logout and close your web browser.
Chapter 2 — Configuring EasyLAN Wireless
Values
Enable,
Disable
LPD,
TCP port,
FTP,
Telnet,
HTTP,
POP3,
SMTP,
SNMP,
NETBIOS,
TFTP
n.n.n.n where n is
from 0 to 255
n.n.n.n where n is
from 0 to 255
n.n.n.n where n is
from 0 to 255
AUTO,
DHCP,
BOOTP,
RARP,
STATIC
0 to 255
Default
Enable
All selected
192.0.0.192
0.0.0.0
0.0.0.0
AUTO
If you manually
enter TCP/IP
parameters, the
boot method
automatically
changes to
STATIC.
3
31