Console Commands; General Console Commands - Intermec EasyLan AW02 User Manual

Appendix A — Console Commands

Console Commands

General Console Commands

90
This section lists and describes the console commands. You can also use
the command to display information about console commands and
help
their related parameters.
These commands let you configure and manage EasyLAN Wireless.
General Console Commands
Command
cl fat
cl po port job
cl protect
cl str string
exit
he
init
save
set default
set loa status
set loa ho name
set loa ip n.n.n.n
Description
Clears the fatal error log.
Aborts the current print job on the specified port. If
the remote host is still connected, any further data is
discarded. Where port identifies the port.
Disables the console update password, which
protects access to the commands. For help, see
set
the
set protect password
Clears the specified service string table entry. Where
string identifies the service string table entry.
Exits the EasyLAN Wireless console.
Displays help for console commands.
Type or for a complete list of commands.
he help
Or, type
help command
command.
Resets EasyLAN Wireless software.
Saves the current configuration to non-volatile
memory.
Sets EasyLAN Wireless to the factory default
settings.
Be aware that this command will reset your network
parameters and you may lose network
communications.
Allows or disallows the firmware to reload after the
next exit command. Where status is
to disable. The default is disabled.
dis
Sets the node name of the NetWare boot host.
Where name is the host name.
Sets the IP address of the source computer for a
TFTP operation. Where n is a number from 0
get
to 255. The default is 0.0.0.0.
EasyLAN Wireless User's Manual
command.
for help on a specific
to enable or
en