Intermec EasyLan AW02 User Manual page 58

Chapter 2 — Configuring EasyLAN Wireless
46
8 Delete the last five pairs of hexadecimal digits (usually
).
01
9 From the beginning of the key, delete all hexadecimal pairs up to and
including the first 00. In the screen capture for Step 7, you would delete
30 81 89 02 81 81 00
10 Delete all of the spaces, press Ctrl-A, and then press Ctrl-C.
11 Connect EasyLAN Wireless to your PC serial port and enable Console
mode. For help, see "Connecting EasyLAN Wireless to Your PC" on
page 9.
12 On your PC, open a HyperTerminal session. You must use the serial
communications settings shown in the next table.
Parameter Required Value
Baud rate 115200
Data bits 8
Stop bits 1
Parity None
Flow control None
13 Press Enter to get the
Instead of the
Local>
the prompt. For help, see Step 3 on page 89.
Boot>
14 Type
set en ttkey \x
and then press Enter.
15 To make sure that the authentication is set, type
then press Enter.
16 To save the changes, type
17 Type and press Enter.
exit
.
prompt.
Local>
prompt, you might see the
, select Edit > Paste To Host to paste the key,
, press Enter, type
save
EasyLAN Wireless User's Manual
02 03 01 00
prompt or
Local:
, and
sh en ttkey
, and press Enter.
ini