Table of Contents
Advertisement
EasyLAN Wireless User's Manual
General Console Commands (continued)
Command
set loa so filename
set loa TFTP
set loa xm
set pa password
set poweron nn
set protect password
Appendix A — Console Commands
Description
Sets the filename on the host of the firmware to
load. The default is lcim.bin.
Initiates a firmware update via a TFTP
operation. You must set the TFTP server address
with the
set loa ip n.n.n.n
must set the file name with the
command. The server resets when the
filename
firmware update is complete.
Initiates a firmware update via the serial console
using the XMODEM protocol. The server resets
when the firmware update is complete.
Sets the console password, which protects access to
the console. Where password is the case-sensitive
password.
You can also set this password with the Configure
Network Card Access Password command in the
web browser interface, as described on page 26.
The default password is
intermec
Sets the power on delay. Where nn is the amount of
time of the delay in seconds. The default is 0 (no
delay).
Sets the console update password, which protects
access to the
commands. Where password is the
set
case-sensitive password.
You can also set this password with the Configure
Network Card Update Password command in the
web browser interface, as described on page 27.
By default, this password is not enabled.
If this password has been set, the
(instead of
) appears when you enter the
Local>
console. From the
Local:
view configuration settings.
To temporarily gain access to
can use the
command and enter the
unpro
password when prompted. The
appears. You can use
commands until you use
set
to end the console session.
exit
You can disable the console update password with
the
command.
cl protect
get
command. You
set loa so
in lowercase.
prompt
Local:
prompt, you can only
commands, you
set
prompt
Local>
91
Advertisement
Table of Contents
Troubleshooting
