Connecting Easylan Wireless To Your Pc - Intermec EasyLan AW02 User Manual

Connecting EasyLAN Wireless to Your PC

1 2 3 4 5
6 7 8 9
EasyLAN Wireless User's Manual
12-Foot Long Cable With Magnetic Base at the Antenna Connector (P/N 060749):
Use with the antenna that came with EasyLAN Wireless.
To initially configure EasyLAN Wireless, you must connect its serial port
to your PC serial port.
The EasyLAN Wireless serial port is a PC-compatible 9-pin male D-
connector. You can order a 9-pin female to 9-pin female serial cable from
Intermec (P/N 059167). The pinouts for this cable are shown in the
illustration on the next page.
Note: The EasyLAN Wireless serial port is a "console-only" serial port,
which you can use only to configure EasyLAN Wireless with the EasyLAN
Network Setup configuration wizard or console commands. For a list of
required serial communications values, see page 12.
To connect EasyLAN Wireless to your PC serial port
1 Make sure you have the serial cable from Intermec (P/N 059167).
You may use another cable that connects input signals (such as Receive
Data) on EasyLAN Wireless to the equivalent output signals (such as
Transmit Data) on the PC, and vice-versa, as shown on the next page.
2 Plug one end of the serial cable into the serial port of EasyLAN
Wireless, and plug the other end into the serial port of your PC.
Chapter 1 — Installing EasyLAN Wireless
9