Avalanche Console Commands - Intermec EasyLan AW02 User Manual

Avalanche Console Commands

EasyLAN Wireless User's Manual
POP3 Console Commands (continued)
Command
set pop3 pa password
set pop3 ti nn
sh pop3
These commands let you enable and disable Wavelink Avalanche and set
the IP address for the Avalanche Console.
Avalanche Console Commands
Command
cl ava
set ava status
set ava ip n.n.n.n
sh ava
This example on the next page shows the commands in a HyperTerminal
to disable Avalanche, show that it is disabled, enable Avalanche, and show
the factory default settings.
Local> set ava dis
Local> save
Local> init
Server will reset on exit
Local> sh ava
Avalanche is disabled
Local> set ava en
Local> save
Local> sh ava
Console IP address: 0.0.0.0
Avalanche is enabled
Properties set:
Owner 1 Key 'COOKIE' Value 41 38 41 41 30 38 42
Owner 1 Key 'TerminalID' Value '689'
Appendix A — Console Commands
Description
Sets the password of the POP3 mailbox. The default
is NULL.
Sets the POP3 message timeout (in minutes). The
default is 120 minutes.
Shows the POP3 parameters.
Description
Clears the Avalanche parameters.
Enables or disables the EasyLAN Wireless to be
managed by the Wavelink Avalanche client
management system. Where status is
or for disabled. The default is anabled.
dis
Sets the Avalanche agent IP address. Where n is a
number from 0 to 255. The default is 0.0.0.0.
Displays the list of packages that are installed via
Avalanche and the properties that have been set.
for enabled
en
103