Tcp/Ip Console Commands - Intermec EasyLan AW02 User Manual

TCP/IP Console Commands

EasyLAN Wireless User's Manual
General Console Commands (continued)
Command
sh poweron
sh serial
sh serve
sh serve co
sh servi item
sh str stringnumber
sh te
sh ver
unpro
ze
These commands let you configure and display TCP/IP parameters.
TCP/IP Console Commands
Command
set ip ac status
n.n.n.n
set ip ad n.n.n.n
Appendix A — Console Commands
Description
Shows the power on delay (in seconds).
Shows the serial number of the EasyLAN Wireless.
Shows the EasyLAN Wireless server parameters.
Shows the EasyLAN Wireless server network
statistics, such as Bytes Received and Bytes Sent.
Shows the service parameters. Where item can be
for filters, for NDS parameters,
fil nds
for the priority of a service,
service
to define the BOT and EOT
stringnumber
strings used in services,
sum servicenumber
the basic parameters of a service number.
Shows the BOT and EOT strings used in services.
Where identifies the string. If you
stringnumber
do not specify a string number, all string definitions
are displayed (but not the expansions).
Prints the test label or test page.
Shows the EasyLAN Wireless firmware version.
Allows the system manager to temporarily access the
commands when the remote console is in
set
protected mode. Protected mode is enabled when
you configure a console update password with the
set protect password
You can permanently disable this console update
password with the
cl protect
Or you can use the
set default
restore the default configuration (by default, this
password is not enabled). Be aware that restoring the
default configuration resets your network parameters
and you may lose network communications.
Clears and resets the network statistical counters.
Description
Enables or disables a specified IP address from
accessing EasyLAN Wireless. Where status is
enabled, for disabled, or
dis
addresses and n is a number from 0 to 255. The
default is an empty list of IP addresses.
Sets the IP address of the EasyLAN Wireless. Where
n is a number from 0 to 255. The default is
192.0.0.192.
pri
str
for
command.
command.
command to
for
en
for enabling all IP
all
93